Thingiverse
Cable holder
von GerOntivero
1
Downloads
1
Likes
0
Makes
It's not fully tested yet, but it's a good first version of a one-piece for winding and holding cables.
My goal is to make it completely parametric, so when I finish it I will upload the file for openSCAD
My goal is to make it completely parametric, so when I finish it I will upload the file for openSCAD
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!