Thingiverse
Cable rack
door pmiddelink
32
Downloads
20
Likes
0
Makes
This is a small project I started this weekend to organize my (mostly USB) cables better. I already had a similar rack made from metal, but figured 3D printing is a thing now, so...
The design tries to minimize on plastic by supporting each "finger" with two thin walls, allowing you to print without supports. I strongly suggest you print it with the back on the plate, as it gives much better adhesion. (Printing with the "fingers" flat on the bed, prints faster but I had severe difficulties having all the 24 thin walls to stick properly to the bed, YMMV)
The Fusion 360 design is parameterized for the number of fingers and screws.
The design tries to minimize on plastic by supporting each "finger" with two thin walls, allowing you to print without supports. I strongly suggest you print it with the back on the plate, as it gives much better adhesion. (Printing with the "fingers" flat on the bed, prints faster but I had severe difficulties having all the 24 thin walls to stick properly to the bed, YMMV)
The Fusion 360 design is parameterized for the number of fingers and screws.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!