Thingiverse
Cable Tray Bracket
von Mortimyrrh
2
Downloads
2
Likes
0
Makes
My first 3d model.
I received a cable tray from work with brackets that didn't fit. I drew the existing ones out in fusion 360 and edited them so they actually fit the cable tray I had.
Will require some editing if you're wire cable tray has different spacing to mine (2.5cm between metal bars), but it's a good starting point other wise.
Originally printed in cheap PLA with gyroid infill at 2.5mm and 3 walls but broke after 1 year of very heavy use - Swapped to 100% infill for my current ones (Still very cheap PLA).
Best printed on side for strength and minimal supports.
I received a cable tray from work with brackets that didn't fit. I drew the existing ones out in fusion 360 and edited them so they actually fit the cable tray I had.
Will require some editing if you're wire cable tray has different spacing to mine (2.5cm between metal bars), but it's a good starting point other wise.
Originally printed in cheap PLA with gyroid infill at 2.5mm and 3 walls but broke after 1 year of very heavy use - Swapped to 100% infill for my current ones (Still very cheap PLA).
Best printed on side for strength and minimal supports.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
