CableLoop for OpenGrid Underware

The CableLoop is designed for organizing your longer cables as part of the Underware system. The model by JoshPrints was for MultiGrid but I have remixed it to work for openGrid. I totally remade the models to create two types: 3x3 for smaller/shorter cable loops and 6x3 for the longer cables. To use them, you install the snap in the middle of the 3x3 (two snaps for the 6x3, with some separation) and screw in the stud. The stud has some ‘wings’ to help your cable stay in place while you wind it around and then install the cover. There are a variety of inlet and outlet options:3x3StraightU-Turn90° Bend6x3StraightU-Turn90° Bend (plus a mirrored version)S-bend (plus a mirrored version)HMulti (cut the thin walls to decide which outlets to open)On top of the above variations, there is also a ‘Lite’ version which was designed to print a bit faster and save some filament. HOWEVER, I don't recommend using these ones as the holding strength is quite a bit lower. So print these types at your