Thingiverse
calibration cube
von voltarunt
3
Downloads
3
Likes
0
Makes
Simple cube for calibration.
Should be 20x20x20mm in size.
Square hole on side should be 10x10x5mm in size
Round hole should be 10mm in diameter
Square hole with ball should be 10x10x5mm with 8mm ball
Holes on top should be 4x4mm
The two pillars should be 1x3x10mm
Should be 20x20x20mm in size.
Square hole on side should be 10x10x5mm in size
Round hole should be 10mm in diameter
Square hole with ball should be 10x10x5mm with 8mm ball
Holes on top should be 4x4mm
The two pillars should be 1x3x10mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!