Thingiverse
Calibration objects
por jeniik
20
Descargas
12
Likes
1
Makes
So you want your prints to be precise and nice, right?
Print Kalibr1. This is the first step, it has to be 2*1cm, if so you know your steps are OK. You want the inner hole to be perfectly round so that you know you have no play in x and y axes. Try to destroy it, just cut it along the layers to know how well they stick together.
Print Kalibr2. This is just about supports and setting them up.
Print Kalibr3. You should be able to put those radiuses together nicely. If there is a gap in the middle your objects are a bit too large (too much material extruded) and vice versa.
If you succeed in printing all of them then you are ready to print virtually anything.
And if you think that the supports are too hard then you should watch this: https://www.youtube.com/watch?v=T0lRz6sURO4&feature=youtu.be
Print Kalibr1. This is the first step, it has to be 2*1cm, if so you know your steps are OK. You want the inner hole to be perfectly round so that you know you have no play in x and y axes. Try to destroy it, just cut it along the layers to know how well they stick together.
Print Kalibr2. This is just about supports and setting them up.
Print Kalibr3. You should be able to put those radiuses together nicely. If there is a gap in the middle your objects are a bit too large (too much material extruded) and vice versa.
If you succeed in printing all of them then you are ready to print virtually anything.
And if you think that the supports are too hard then you should watch this: https://www.youtube.com/watch?v=T0lRz6sURO4&feature=youtu.be
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
