Thingiverse
Calibration Tower
von regularlabs
37
Downloads
17
Likes
0
Makes
Set your slicer up to use different settings every 10mm.
When printing at 0.2mm layer height, that is every 50 layers.
You can for instance do tests for:
- Temperature (ie increments of 5°C: 260°C - 215°C)
- Print Speed
- Fan Speed
- Flow Rate
- etc...
When printing at 0.2mm layer height, that is every 50 layers.
You can for instance do tests for:
- Temperature (ie increments of 5°C: 260°C - 215°C)
- Print Speed
- Fan Speed
- Flow Rate
- etc...
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
