Thingiverse
Camera Double Headed Stud
door doctorekorea
2
Downloads
3
Likes
0
Makes
This is a double headed stud for camera equipment. 1/4 and 3/8 thread, print with 30% infill and also 100% infill under 100mm^2 on Prusaslicer.
I recommend ABS or tougher material. PETG can work but not as strong, I only recommend for lighter cameras under 2-3 pounds.
I designed it so you don't need supports, print with the bigger 3/8 thread on bottom.
I recommend ABS or tougher material. PETG can work but not as strong, I only recommend for lighter cameras under 2-3 pounds.
I designed it so you don't need supports, print with the bigger 3/8 thread on bottom.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!