Thingiverse
Candy Dispenser
von 380awesomedude2
0
Downloads
1
Likes
0
Makes
This is a little gadget I made in my free time. Assembly requires some glue and that's all!
ASSEMBLY:
1. Glue the bowl to the top, edged, part of the chute.
2. Place the Rotator in the large hole on the chute (The small one is for clearing if jammed and keeps the rotator rotating smoothly)
3. Glue/Tape the handle cover over the rotator.
4. Glue the Dispenser part to the flat bottom of the chute.
5. Place it on top of the Drop Catcher. (Glueing is optional)
ASSEMBLY:
1. Glue the bowl to the top, edged, part of the chute.
2. Place the Rotator in the large hole on the chute (The small one is for clearing if jammed and keeps the rotator rotating smoothly)
3. Glue/Tape the handle cover over the rotator.
4. Glue the Dispenser part to the flat bottom of the chute.
5. Place it on top of the Drop Catcher. (Glueing is optional)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!