Thingiverse
case for bed occupancy sensor
von martikainen87
6
Downloads
2
Likes
0
Makes
The case is made for my bed occupancy sensor https://github.com/martikainen87/Home-Automation/wiki/ESP8266---Bed-Occupancy-Sensor
the inside measurements are 51.5mm x 70.5 which fits the PCB's I'm using (probably standard measurement.
There is 4 "cliffs" at the bottom to leave space for the nodemcu headers.
The big hole is for the USB cable and the small hole for the RFS.
The lid is fastened by using zip-tie's.
The case is made in sketchup 2018, feel free to modify it to your preferences! My next step would be to add screw holes to fasten it under the bed.
the inside measurements are 51.5mm x 70.5 which fits the PCB's I'm using (probably standard measurement.
There is 4 "cliffs" at the bottom to leave space for the nodemcu headers.
The big hole is for the USB cable and the small hole for the RFS.
The lid is fastened by using zip-tie's.
The case is made in sketchup 2018, feel free to modify it to your preferences! My next step would be to add screw holes to fasten it under the bed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!