Thingiverse
Case for simplex MMDVM Raspberry Pi 3A+, SCAD
von mavrsmart
0
Downloads
0
Likes
0
Makes
Case for simplex MMDVM using Raspberry Pi 3A+.
Cooling cutouts turned out to be unnecessary; the device does not heat up much.
The housing is designed for M3x20 bolts. Use two M3x5 bolt to screw the MMDVM board.
Printed with PETG plastic, layer height 0.3
Cooling cutouts turned out to be unnecessary; the device does not heat up much.
The housing is designed for M3x20 bolts. Use two M3x5 bolt to screw the MMDVM board.
Printed with PETG plastic, layer height 0.3
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
