Thingiverse
Case
von KennyThePoopGuy
4
Downloads
3
Likes
0
Makes
Video Instructions of how to construct: https://youtu.be/cFPjMUXTIBM
This is a case for the little camera shocker I made. This is fully 3D printable and very easy to just send off and us.
The holes might need adjusting depending on what type bolts or buttons you use but should fit the standard sized circuit board.
This is a case for the little camera shocker I made. This is fully 3D printable and very easy to just send off and us.
The holes might need adjusting depending on what type bolts or buttons you use but should fit the standard sized circuit board.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
