Casting POT PID Temp controller

I printed this from PLA, the SSR heat sink holes are for M4 cap screws. The lid screws are for M4 screws, no need to tread. I included the BOM below. I ordered the pot included in the BOM but if you already have a POT that is not required. For the cord I used a section of 14ga extension cord. If you are not experienced with wiring you should get someone who is experienced to help, this uses 110 VAC so the risk of shock is real. This controller works really well. If you want to be able to swap thermocouples you'll need to order extra thermocouple plugs.

https://www.amazon.com/dp/B08LBLQJX8?psc=1&ref=ppx_yo2ov_dt_b_product_details

https://www.amazon.com/dp/B092VQNKN7?psc=1&ref=ppx_yo2ov_dt_b_product_details

https://www.amazon.com/dp/B09W9Q5HMH?psc=1&ref=ppx_yo2ov_dt_b_product_details

https://www.amazon.com/dp/B0748DFJFN?psc=1&ref=ppx_yo2ov_dt_b_product_details

https://www.amazon.com/dp/B07SH42DCD?psc=1&ref=ppx_yo2ov_dt_b_product_details

https://www.amazon.com/dp/