Thingiverse
Catamaran for hover:bit
by MakeKit
2
Downloads
0
Likes
0
Makes
See video tutorial: https://www.youtube.com/watch?v=mjkiQWbEbqw
5-10% infill on floaters for low weight. Can be a bit higher on the center base plate.
If you have good bridge settings you can try printing without support for the floaters. (Printed upside down)
Check for water sealing before running on open water. Subdrain in a sink and see if water goes inside. Don´t let it stay in the water for more than 30 min to prevent water to get in.
5-10% infill on floaters for low weight. Can be a bit higher on the center base plate.
If you have good bridge settings you can try printing without support for the floaters. (Printed upside down)
Check for water sealing before running on open water. Subdrain in a sink and see if water goes inside. Don´t let it stay in the water for more than 30 min to prevent water to get in.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!