Thingiverse
Cello support bracket
von Rextus
0
Downloads
0
Likes
0
Makes
A cello support bracket that clamps the cello between its bouts/waists. Interfaces with a 20-2040 extrusion.
Second half of the support is the same part, mirrored. Can be done in the slicer.
If this part doesn't fit exactly with your cello, simply heat it up with a hairdryer, then mold it to the exact shape you need by pushing it in the bouts and holding it there until it has cooled down.
Second half of the support is the same part, mirrored. Can be done in the slicer.
If this part doesn't fit exactly with your cello, simply heat it up with a hairdryer, then mold it to the exact shape you need by pushing it in the bouts and holding it there until it has cooled down.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!