Chisel Shelf

CHISEL SHELF
Dimensions:
Height: 7.0mm
Depth: 8.5mm
Width: 330mm
Slot Dimensions:
Width: 17mm
Depth: 60mm
Once your item has been printed, lightly sand it in preparation for gluing assembly, as follows:

1. Align “A” on top of “B”, by ensuring all edges are flush.
2. You should now have a double stack with “A” on top of “B”. The slot in the center of “B” should be facing downward.
3. Take “C” and rest it along the long edge so the slots are at the top and perpendicular “A” and “B”.
4. Take the “A” & “B” stack, mentioned in paragraph 2, and insert the long-edge tabs into the long edge along the top edge of “C”. (The slot in “B” should still be facing downward.
5. Insert “D” and “E” onto each end of the assembly. The two slots on D should slot into the left side of the assembly, while “E” is installed on the right side.
6. Flip the assembly over and insert “F” into the slots on “B” and “C”.