Thingiverse
Cigarette Case
von Nathan1997
95
Downloads
97
Likes
0
Makes
A cigarette case I designed for my mother in law
I'm an enabler.
Holds 20 cigarettes smaller than 8.5mm in diameter
the walls, lid and bottom are 2mm thick
the internal height of the box is 100mm, 98mm to make sure the latch has room to slide freely, so a bit packing is necessary before putting store bought 100s in.
this isn't a problem for us since we pack our own and it results in the cig being about ~2mm shorter than a proper 100.
I'm an enabler.
Holds 20 cigarettes smaller than 8.5mm in diameter
the walls, lid and bottom are 2mm thick
the internal height of the box is 100mm, 98mm to make sure the latch has room to slide freely, so a bit packing is necessary before putting store bought 100s in.
this isn't a problem for us since we pack our own and it results in the cig being about ~2mm shorter than a proper 100.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
