Thingiverse
Classical Bird Feed House
von projunk
0
Downloads
4
Likes
0
Makes
Classical Bird Feed House
Required Printed Parts:
* Back.stl (1x)
* Floor.stl (1x)
* Front.stl (1x)
* MainPillar.stl (1x)
* RoofLeft.stl (1x)
* RoofRight.stl (1x)
* Side.stl (2x)
* SidePillarLeft.stl (1x)
* SidePillarRight.stl (1x)
Optional Printed Parts:
* AlignmentPinASymmetrical.stl (4x)
* AlignmentPinSymmetrical.stl (3x)
* Bumper (2x) (Ninjaflex 20% infill)
Required non-printed parts:
- cone head screw M3*10 (12x)
- hex head screw M3*20 (6x)
- brass insert nut M3 L4 OD5 (18x)
Recommended Materials:
ABS or PETG (10% infill)
Remark:
* I used metal alignment pins and super glue to attach the roof to the pillars
Required Printed Parts:
* Back.stl (1x)
* Floor.stl (1x)
* Front.stl (1x)
* MainPillar.stl (1x)
* RoofLeft.stl (1x)
* RoofRight.stl (1x)
* Side.stl (2x)
* SidePillarLeft.stl (1x)
* SidePillarRight.stl (1x)
Optional Printed Parts:
* AlignmentPinASymmetrical.stl (4x)
* AlignmentPinSymmetrical.stl (3x)
* Bumper (2x) (Ninjaflex 20% infill)
Required non-printed parts:
- cone head screw M3*10 (12x)
- hex head screw M3*20 (6x)
- brass insert nut M3 L4 OD5 (18x)
Recommended Materials:
ABS or PETG (10% infill)
Remark:
* I used metal alignment pins and super glue to attach the roof to the pillars
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
