Thingiverse
Clearance Tolerance Test
von pyromra
14
Downloads
10
Likes
0
Makes
A custom clearance test I made to determine at what increments I need to print separate parts to allow them to fit together and at what tightness.
Print this in the resolution you want the finest control over.
I was able to get a snug fit at +.2 with +.15 being pressure fit stuck and I had to use a tool to release it.
Print this in the resolution you want the finest control over.
I was able to get a snug fit at +.2 with +.15 being pressure fit stuck and I had to use a tool to release it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
