Thingiverse
Clock plot case
von DIYhans
2
Downloads
3
Likes
0
Makes
I changed this case for arduino nano with nano shield extension board.
The clock module I used was DS3231 IIC.
I also combined the top with the case in one print.
The knob for activating the draw was replaced by a small 12 x 12 x 6 mm touch switch.
The other components are from the clock from TuckerPi
The clock module I used was DS3231 IIC.
I also combined the top with the case in one print.
The knob for activating the draw was replaced by a small 12 x 12 x 6 mm touch switch.
The other components are from the clock from TuckerPi
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
