Cockroach

This is a cockroach-shaped magnet with simple linkage between the left and right wings. After installation, the wings can be spread out at an angle of about 60 degrees. You can own it with less than 12g.Note: The damping may be a little large when it is just printed, and it will get better after repeated use (because the wings are relatively thin, it is not recommended to move the wings vigorously in the early stage)Two D15mm*3mm magnets are built inPlease be careful when installing to avoid breaking the pile. It is best to use tools. The author used a vernier caliper to assist in installation (slightly separate the two teeth of the vernier caliper to make it slightly larger than the pile body, and press it on a stable table. At the same time, everyone is welcome to give suggestions. 这是一只蟑螂外形的磁贴，左右翅膀有简易联动，翅膀安装后大约有60度展开角度，仅需12g不到，你即可拥有它注意：刚打印出来阻尼可能有一些大，多次使用后会有好转（因翅膀部分较为薄，所以在初期不建议大力移动翅膀）里面内置了两颗D15mm*3mm的磁铁在安装时请小心，以免断桩，最好借助工具,作者用到了游标卡尺来辅助安装(将游标卡尺的两个齿略微分开，使其略大于桩体，在平稳桌面上进行按压，同时欢迎大家来提意见哦