Thingiverse
Codenames Box
von Gmartin314
2
Downloads
1
Likes
0
Makes
My take on the many codenames boxes out there, nice and compact to fit in a bag, and no messing around with plastic bags. Designed to use as little filament as possible while remaining sturdy, with a snap on lid rather than a full cover.
Despite the 'exposed' cards, nothing can get out until you remove the lid, which is firmly held on by three hooks. To release it you flex the box (not the lid) and it pops right out. There are also holes for some 3x2 magnets, which it turns out aren't required for it to stay shut, but do provide a very satisfying closing experience.
No room for the sand timer, because I never use it anyway.
Despite the 'exposed' cards, nothing can get out until you remove the lid, which is firmly held on by three hooks. To release it you flex the box (not the lid) and it pops right out. There are also holes for some 3x2 magnets, which it turns out aren't required for it to stay shut, but do provide a very satisfying closing experience.
No room for the sand timer, because I never use it anyway.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
