Thingiverse
Collapsing Broadsword (Removable "sharp" Blade)
por J4bberwock
81
Descargas
52
Likes
1
Makes
By popular request, here is a new broadsword with a "sharp" blade instead of the rounded one.
Hilt and cap have been uploaded.
The blade is fully functionnal and tested, operates smooth, and locks fine.
All blade segments are to be printed in vase/spiral mode 0% infill with a 0.4mm nozzle, line width set to 0.8mm.
I used 0.2mm layer height.
0.12mm 50% infill for the hilt and cap, but 0.2mm and 20% infill should be ok too.
The blade on the left of the pictures that stays larger will be for my next design, the sword of Omens.
Hilt and cap have been uploaded.
The blade is fully functionnal and tested, operates smooth, and locks fine.
All blade segments are to be printed in vase/spiral mode 0% infill with a 0.4mm nozzle, line width set to 0.8mm.
I used 0.2mm layer height.
0.12mm 50% infill for the hilt and cap, but 0.2mm and 20% infill should be ok too.
The blade on the left of the pictures that stays larger will be for my next design, the sword of Omens.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!