Thingiverse
Comic Book Wall Mount
von noahdpj
4
Downloads
12
Likes
0
Makes
The printer I used for this is the Ender 3. This print will only work for certain printers depending on the volume your print can build on.
Infill 10-30%
Print temp 215 C
Layer height .3 mm
Support normal, 65 overhang, 2% density
Infill 10-30%
Print temp 215 C
Layer height .3 mm
Support normal, 65 overhang, 2% density
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!