Thingiverse
Compact Loose Filament Spool
von Department_Nine
776
Downloads
553
Likes
1
Makes
Filament samples and leftovers need a good home: let this compact and robust two-part spool take care of them.
This design is based on its big brother, the Loose Filament Spool.
For 1kg refills, use the UniReel.
Design Features
Full-height hub makes it easy to add filament
Prints without supports
Works without fasteners: bayonet fit joins spool parts
Automatic latch stops the parts rotating apart
Integrated filament "clips" hold start and end of filament
54mm diameter spool hub fits most spool holders
Filament hub is 90mm diameter and 26mm wide for most samples and loose filament
130mm outside diameter
It's bloody tough
The optional hub extension (normal and tech versions) increases the internal width to 58mm (needs supports under the latch)
The optional lead-in cone helps with big and/or stubborn filament
Check out more printer accessories from Department_Nine including larger and dedicated refill versions.
This design is based on its big brother, the Loose Filament Spool.
For 1kg refills, use the UniReel.
Design Features
Full-height hub makes it easy to add filament
Prints without supports
Works without fasteners: bayonet fit joins spool parts
Automatic latch stops the parts rotating apart
Integrated filament "clips" hold start and end of filament
54mm diameter spool hub fits most spool holders
Filament hub is 90mm diameter and 26mm wide for most samples and loose filament
130mm outside diameter
It's bloody tough
The optional hub extension (normal and tech versions) increases the internal width to 58mm (needs supports under the latch)
The optional lead-in cone helps with big and/or stubborn filament
Check out more printer accessories from Department_Nine including larger and dedicated refill versions.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
