Thingiverse
Computer Headphone Holder
von Hyudryu
7
Downloads
5
Likes
0
Makes
A very simple headphone holder I created. It's designed to be assembled using a 1/8" dowel pin of ~23mm length. Although I just cut off a small segment from a 1/8" stainless TIG filler rod and that works great too.
In order to secure the mount onto the side of your monitor, I would recommend using 3M VHB double sided tape.
The two pieces are meant to be printed as-is, no supports needed. PLA+/PETG works great.
In order to secure the mount onto the side of your monitor, I would recommend using 3M VHB double sided tape.
The two pieces are meant to be printed as-is, no supports needed. PLA+/PETG works great.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
