Computer wire tray

This is a modular tray that plugs into itself to make a wire tray as long as you need. For me, this screws into the back of my desk to hold my mess of wires and power supplies off the floor. This Thing saved my marriage! :-)

Features:
- there are three body stl files:
1) main body with access holes
2) short end body that supports the last section of the tray
3) main body w/o access holes that you can cut to fill out the tray to an exact length
- There are three cover stl files:
1) single clip to retain wires
2) full cover (but it doesn't cover the tray joint area)
3) full cover with access hole (print 2 to complete cover)
- small mounting holes and opposing larger holes for drill and screwdriver access.
- stand-off on bottom for a small zip tie
- can be mounted vertical (shown) or horizontal. For horizontal, the clip.stl or cover.stl will be needed to retain the wires in the tray

Each tray is about a 7 hour print. The body stl files have