container with hinged lid version 2

These are my multipurpose containers with a hinged lid without any screws or glue - version 2!Very easy print, no support needed! The model consists of: 2 parts, container and lidTools needed: none!Additional parts needed: none! Assembly instructions:place the lid face down on a deskallign the body upside down with the hingenow press carefully on the upper edge, so that the body snaps into the hingeRecommended filament: PLA Hotend: 0,40mm Print instructions for PLA (my print profile is set up like this):layer height: 0,20mm3 wall loopstop/bottom shells: 4 layerstop/bottom shell thickness: 0,80mminfill: 10%sparse infill pattern “gyroid”Enable “Infill combination”seam on backouter brimBefore printing, make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesive. I repeat the process every 5-6 prints.Bad build plate adhesion is not re