Thingiverse
Controller box
door 09ZX-6R
43
Downloads
29
Likes
0
Makes
switch / control box with a display for volts and amps from the power supply... helps to monitor the output to the printer controller...total cost was $10 USD.
printed in PLA
.20mm layer height
no raft
support material "ON"
heated bed @ 55C with kapton tape
printed in PLA
.20mm layer height
no raft
support material "ON"
heated bed @ 55C with kapton tape
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
