Thingiverse
CR-10 Solid Bed Mount with Camera Arm and Cable Chain
von prider
5
Downloads
1
Likes
0
Makes
This is a remix for solid bed mounts for the CR10, using both a camera arm as well as cable chain strain relief. I've listed the changes I've made to each part below.
Changes to Strain Relief Cable Chain part:
Simply made the end a solid cylinder.
Changes to Webcam Mount Logitech C270:
Added a solid section at the end of the arm, trimmed the long excess of the end of the
arm off, and removed the cable slot from one side for easier printing.
If you need the cable slot on the other side then mirror the part in your slicer.
Changes to Strain Relief Cable Chain part:
Simply made the end a solid cylinder.
Changes to Webcam Mount Logitech C270:
Added a solid section at the end of the arm, trimmed the long excess of the end of the
arm off, and removed the cable slot from one side for easier printing.
If you need the cable slot on the other side then mirror the part in your slicer.
prider veröffentlicht auch auf
16 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
