Thingiverse
Creality printer basic status display
por ZefDurgen
0
Descargas
0
Likes
0
Makes
Clean LED holes to fit snugly or use hot glue to hold them in place. I used a 10-conductor ribbon cable to connect to the mainboard. I used M4 T-slot bolts and nuts to mount the display on the rail.
Connections are noted for Creality Ender series printers running 24-volt heaters.
Green LEDs are spliced into limit switches no need for resisters.
The red LEDs connect to heater outputs with a 2k ohm resistor on the negative lead.
Use superglue to attach lid to body.
Connections are noted for Creality Ender series printers running 24-volt heaters.
Green LEDs are spliced into limit switches no need for resisters.
The red LEDs connect to heater outputs with a 2k ohm resistor on the negative lead.
Use superglue to attach lid to body.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!