Creality wall clock

I designed this Creality logo wall clock for a bit of fun.It's been designed to be printed in separate parts, as the best orientation for the green front section is printed upright to avoid a rough finish through layer lines.The wall hanging bracket attaches via a thumb screw to make printing the base easier by printing it flat.I bought the clock mechanism from Amazon - they all seem to be much the same, the clock mechanism dimensions are 56mm x 56mm x 16mm, with a maximum mounting depth of 9-11mm.Ignore the additional cut out on the rear section in my picture. This was originally for a 3aa battery pack to power an led strip inside to make it glow, but it didn't look good so I've removed it.Printed on my K1 max in pla+ with the below settings:0.2mm layer height - 0.25mm initial layer14mm3/s max volumetric speed0.4mm nozzleTree hybrid supports for the green front part, 2 layer raftNormal snug supports for the base3 walls4 top/bottom layers10% gyroid infill220c hot endGeco build plate so bed unheatedPlease post pics of your completed print, and please consider giving me a boost if you like the design.