Thingiverse
crf250F starter button replacement
door The_Printing_Guy585
0
Downloads
0
Likes
0
Makes
Broke my starter button off so I made a new one.
Tips
You will have to trim two things. Part of the bracket that holds the button itself and the button housing. In the pictures above you can see where to trim. Disclaimer it is not my fault if you take too much off trim a little at a time and try to put the part in after every cut. You might also have to sand the sides of the button to make it slide nicely.
It might just be my slicer but blender files import vary small so I have to scale them up. If you have to do the same make shure that uniform scaling is turned on thet set the Y to 1.19 inches or 30.22 mm pictures above.
Tips
You will have to trim two things. Part of the bracket that holds the button itself and the button housing. In the pictures above you can see where to trim. Disclaimer it is not my fault if you take too much off trim a little at a time and try to put the part in after every cut. You might also have to sand the sides of the button to make it slide nicely.
It might just be my slicer but blender files import vary small so I have to scale them up. If you have to do the same make shure that uniform scaling is turned on thet set the Y to 1.19 inches or 30.22 mm pictures above.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!