crf250F starter button replacement

Broke my starter button off so I made a new one.

Tips

You will have to trim two things. Part of the bracket that holds the button itself and the button housing. In the pictures above you can see where to trim. Disclaimer it is not my fault if you take too much off trim a little at a time and try to put the part in after every cut. You might also have to sand the sides of the button to make it slide nicely.

It might just be my slicer but blender files import vary small so I have to scale them up. If you have to do the same make shure that uniform scaling is turned on thet set the Y to 1.19 inches or 30.22 mm pictures above.