Crib Riser

Initially designed for the Mamas and Papa's crib ‘Lua bedside crib’. Our baby always prefers to be at a slight angle when sleeping. Initially we used a few books wedged under one leg of the bed and I thought I could “definitely over-engineer and waste time doing something thouroughly unnecessary when I should be helping out” (not my words). So I thought I'd publish it here so you don't have to. Printed with 20% infill on the A1. I wanted it to be strong and tried to hollow out as much as I could to save filament but keep it strong. I was going to reduce the width to just the 46mm width of the crib's legs but I thought this would be easier and would fit other cribs if necessary. I printed it with PLA and it's held up well under the weight with 2 of them to spread the weight. Printing this and using it is completely at your own risk and I accept no responsibility for it's use/breaking. I just made this because I was bored of my books propping up the baby's bed