Thingiverse
Crossbow
von Bat27
0
Downloads
1
Likes
0
Makes
This is a crossbow with a bolt. You just string a rubber band through the top two holes and you are done
Print Settings:
Layer height: 0.2mm
Print speed: 80mm/s
Wall speed: 30mm/s
Infill: 20%
Supports: Yes
Build plate adhesion: Brim
Print Settings:
Layer height: 0.2mm
Print speed: 80mm/s
Wall speed: 30mm/s
Infill: 20%
Supports: Yes
Build plate adhesion: Brim
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!