Thingiverse
Custom Lightsaber
door AlexanderGi
36
Downloads
24
Likes
0
Makes
I made a lightsaber at work, but wanted to share a 3D printable version.
It was half inspired by both Luke and Obi-Wans lightsabers.
Just put down a small bit of glue where all the joints are and assemble as pictured.
Part #8 will need supports, the rest should be fine without.
Print orientation is shown, you will need x3 of the #13 pins and x2 of the #14 pins.
It was half inspired by both Luke and Obi-Wans lightsabers.
Just put down a small bit of glue where all the joints are and assemble as pictured.
Part #8 will need supports, the rest should be fine without.
Print orientation is shown, you will need x3 of the #13 pins and x2 of the #14 pins.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
