Thingiverse
Customisable Ring Box
von kajiiiii97
1
Downloads
2
Likes
0
Makes
Created this because I was procrastinating work.
It's customizable, just load it into your favourite 3D modelling software and change the diameters of the circles.
The holes on the sides are for 6mm magnets. You need 8 of them. Or, alternatively, you can extrude one side of the holes up past the surface by 3mm to make it like a peg fitting thingy. Just makes sure its not too tight or you might not see your ring again.
It's customizable, just load it into your favourite 3D modelling software and change the diameters of the circles.
The holes on the sides are for 6mm magnets. You need 8 of them. Or, alternatively, you can extrude one side of the holes up past the surface by 3mm to make it like a peg fitting thingy. Just makes sure its not too tight or you might not see your ring again.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
