Thingiverse
Customizable Flashlight Diffuser Cap
door cdcrockett
152
Downloads
76
Likes
3
Makes
Parametric diffuser cap for flashlights.
--- Update 2014-06-18 ---
Add the ability to put a notch in the side wall to make room for a lanyard to allow storing the diffuser on the back of a flashlight with a lanyard.
--- Update 2014-11-06 ---
I wanted to use a Cellphone charm strap to hang this off of my Fenix LD01 (because, of course, I lost the previous one) so I added the ability to create a hole in the side opposite the notch, then printed a new one out in glow-in-the-dark filament.
--- Update 2015-05-27 ---
Added anti-roll feature, the ability to specify the length (to make light wands) and a few pre-rendered versions for flashlights I have on hand.
--- Update 2014-06-18 ---
Add the ability to put a notch in the side wall to make room for a lanyard to allow storing the diffuser on the back of a flashlight with a lanyard.
--- Update 2014-11-06 ---
I wanted to use a Cellphone charm strap to hang this off of my Fenix LD01 (because, of course, I lost the previous one) so I added the ability to create a hole in the side opposite the notch, then printed a new one out in glow-in-the-dark filament.
--- Update 2015-05-27 ---
Added anti-roll feature, the ability to specify the length (to make light wands) and a few pre-rendered versions for flashlights I have on hand.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!