Thingiverse
Customizable Ring Holder
von mrkmg
120
Downloads
120
Likes
1
Makes
A customizable ring holder!
When printing, customize the bottom to be a little bit larger than the size of the ring. When you drop the ring on it, give it a little push down and it will become snug against the pole. Then, your ring will be less likely to fall off if the holder is tipped for some reason.
Also has a cup for earrings or other jewelry. To remove the cup, set the cup thickness to 0 and reduce the diameter of the base.
When printing, customize the bottom to be a little bit larger than the size of the ring. When you drop the ring on it, give it a little push down and it will become snug against the pole. Then, your ring will be less likely to fall off if the holder is tipped for some reason.
Also has a cup for earrings or other jewelry. To remove the cup, set the cup thickness to 0 and reduce the diameter of the base.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!