Thingiverse
Customized switch
von KLucky13
5
Downloads
5
Likes
0
Makes
Nothing special about this switch. I just thought the original switches are sitting a bit loose and making them "noisy" when flipping the board. This one is a bit bigger and fits the board a bit better imo (not tight at all).
Also the gates are a bit loose, but I just scaled up the original gates found at "Printallot"'s design. I scaled them up in Cura with these ratio's:
X = Width of the gate when put on the board = 1,05
Y = Height of the gate when put on the board = 1,0 (unchanged)
Z = Thickness = 1,26
If you like the game, support "PrintAllot" and buy the game as a present maybe?
Also the gates are a bit loose, but I just scaled up the original gates found at "Printallot"'s design. I scaled them up in Cura with these ratio's:
X = Width of the gate when put on the board = 1,05
Y = Height of the gate when put on the board = 1,0 (unchanged)
Z = Thickness = 1,26
If you like the game, support "PrintAllot" and buy the game as a present maybe?
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!