Cuttlefish Bone Tray

# Cuttlefish Bone Tray for Exotic Birds
##A tray with a clip to hold cuttlefish bones.

### Features:
* 1 top support to keep the bone in place
* 1 hole in bottom to mount on a stand or tie/pin the bone through
* 4 notches on the sides to tie the bone down with twine or rubber bands
* 3 hooks on the back to hang from a cage wall

Hooks are on the back are .45" wide/tall and spaced to fit a 1/2" wire grid or 1/2" hardware-cloth cage.

Pictured below hanging from wire cage and with 1/2 a "large" cuttlefish bone tied in with twine.

Can be printed quickly at low-quality settings with low infill... mine was ~5g of PLA and printed in ~30 minutes.

Note: The Clip overhanging the tray is printed at a downward angle to take advantage of the way that layer lines naturally create "teeth" that will grip the bone a little better than a smooth bar. This also reduces the amount of support material necessary to print.
Printed in PLA at 100%, the clip should be flexible-enough to bend