Thingiverse
D Link - CH341A Programmer Case
von CodenameGamma
33
Downloads
29
Likes
0
Makes
This is a case for the CH341A Programmer avalible here: https://www.amazon.com/risingsaplings-Programmer-CH341A-Burner-EEPROM/dp/B09FLBYM87
to make it fit, i removed the rom holder and pin headers then bridged the jumper manually with solder to make it as flat as possible.
to make the dim connection your going to need an Micro SDCard breakout. i used this one, https://www.amazon.com/ANMBEST-Adapter-Interface-Conversion-Arduino/dp/B08CMLG4D6 and glued it at the back board side facing up to get the card laying on the board as flat as possible.
to make it fit, i removed the rom holder and pin headers then bridged the jumper manually with solder to make it as flat as possible.
to make the dim connection your going to need an Micro SDCard breakout. i used this one, https://www.amazon.com/ANMBEST-Adapter-Interface-Conversion-Arduino/dp/B08CMLG4D6 and glued it at the back board side facing up to get the card laying on the board as flat as possible.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!