DAD hueforge

Made this hueforge for my Dad, I saw many mom hueforge models on internet but not a one that mentioned Dad, so decided to make one myself. Here are the hueforge configuration:Note: I did not had any official bambulab filaments, so I made that from the once I already had. Project: dadHue.hfpPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 175x175mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 2.2mm and the Actual Depth is 2.3mmFilaments Used: PLA PolyLite Black Transmission Distance: 0.3 PLA BambuLab Basic Red Transmission Distance: 3 PLA BambuLab Matte Lilac Purple Transmission Distance: 2 PLA BambuLab Basic Jade White Transmission Distance: 5This print uses 4 unique filamentsSwap Instructions: Start with Black At layer #9 (0.8mm) swap to Red At layer #13 (1.12mm) swap to Lilac Purple At layer #16 (1.36mm) swap to Jade White for the rest. For the frame, you can use this project to generate frame for