Dagger (model rocket)

Chat i may have cooked. this thing should be absolute cinema. 100% 3d printed. Can be made by anyone. Only 3 pieces!!!!!
1x nosecone
1x tube
1x engine holder
In your slicer, disable uniform scaling and extend the tube to 250 mm on the z. If your printer cannot do 250, just do the longest you can.

So this is pretty self explanatory, but on the tube you will notice that at one end the wall is thinner. This is where the nosecone goes in. Print it with the thinner end up top to not need supports (seriously, who wants supports?)
To build, you start by putting the tube on the engine mount. Congrats! You have completed half of the building.
Next, get a piece of paper, scissors, a bunch of rubber bands and some glue. Hot glue works for this too. Now, cut the rubber bands in half and tie each rubber band to each other until you get one long rubber band. This is your shock cord. Now, take your piece of paper and cut out a small piece, around 3/4 inch by 2 inches. Fold this into thirds so that