DarkStar Rocket

This can be printed in PLA, but it has a higher failure rate due to the extreme temps of the ejection charge. I am currently working on different rocket types that will hopefully be more inclusive with less materials needed after printing. Follow me to be notified when these models are posted! E Version Available NowBoost MeIf you enjoy the model and would like to see more model rockets, please Boost Me!This model rocket is design to fly on 1/2 A to C motors. There is also a capability to fly it as a two-stage rocket. Below are the open rocket models for both the single and two stage versions. This rocket should be able to fly on any A-C motor just fine, the only issue is delay charges. Shorter delay charges may cause the nose cone to eject before apogee. Please note that PAHT-CF was chosen to prevent melting of the rocket. It could possibly survive on PLA or ABS. At the bottom of the page is an example of how the rocket is put together along with how motor retention is done. Single:Si