Thingiverse
Deej Case
by sophie1453
8
Downloads
4
Likes
0
Makes
A case for holding all the bits for building a Deej (https://github.com/omriharel/deej)
This particular one has 5 volume controls and an extra knob on the side for controlling the LED brightness incase I want them off or generally dimmer. I've got the LEDs programmed to maintain their hue but dim/brighten with the set volume. Logos are two tone with a pause during printing to swap the filament so there's less color bleeding around the logo.
The LED mount has small pips at the center alignment of the hole in the top case when it's slotted in and the base arduino holder is sized for an arduino nano.
Screw holes are sized for M3 screws to self tap (2.7mm diameter) , potentiometer holes are 7.75mm diameter, switch holes are 6.75mm diameter.
Particular LEDs in this are WS2812B controlled with FastLED library, switches are SPDT toggle switches, Potentiometers are 10k ohm rotary.
This particular one has 5 volume controls and an extra knob on the side for controlling the LED brightness incase I want them off or generally dimmer. I've got the LEDs programmed to maintain their hue but dim/brighten with the set volume. Logos are two tone with a pause during printing to swap the filament so there's less color bleeding around the logo.
The LED mount has small pips at the center alignment of the hole in the top case when it's slotted in and the base arduino holder is sized for an arduino nano.
Screw holes are sized for M3 screws to self tap (2.7mm diameter) , potentiometer holes are 7.75mm diameter, switch holes are 6.75mm diameter.
Particular LEDs in this are WS2812B controlled with FastLED library, switches are SPDT toggle switches, Potentiometers are 10k ohm rotary.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!