DeltaTestObjects

I've added a quick version using the round one in the note below.
AND I've modified that one too :)
With just the arcs and not a continuous rim, there are sometimes bumps at the ends that mess up the measurements so here is one without the gaps. The picture shows the earlier one with gaps.
As I can easily take the build plate off for measurements, there was no need for it to hold together. This quick one makes multiple readings for adjustments much faster and uses less filament.
Also, there is a 100mm vertical test piece that needs to be run first to adjust the "DEFAULT_AXIS_STEPS_PER_UNIT"

NOTE!!!!
I recommend you don't use my original, but look at this one that was based on it...
http://www.thingiverse.com/thing:1557870
A much better job as it is actually smooth around!



Test print for adjusting a Delta Printer that has uneven prints.
Make sure it is printed centrally on your printer.

The notes here are from torsti76 on the Deltaprintr forums, thank you :)

"