Devil Teaching

Created with HueForge Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 220x220mm in size Swap Instructions: Start with Black At layer #11 (0.96mm) swap to Gray At layer #19 (1.6mm) swap to White for the rest. The attached picture has a plain 3D printed frame, just search for what you require on Maker World and filter by “parametric” , I always give it an extra 1mm on each side (i.e. for this one it would be 221 by 221 mm)For this print I used Sunlu Black PLA, Bambu Grey PLA and Bambu White PLA. I have used other brands for similar prints and because of the high contrast I have not had a problem so far. If you get an error message regarding floating regions this can be ignored after slicing. Enjoy!