Slicer Discord
Dice Corner – 3D-Druckmodell von MyMiniFactory MyMiniFactory
Accessories

Dice Corner

0 Downloads
17 Likes
0 Makes
Zum Modell
"There are times when your little ones (dice) aren't rolling well. They may be overwhelmed by the situation or can't communicate their needs effectively which leads them to act out in ways that may not be the beneficial to your game. At Questline, we believe that big dice emotions are valid and that feeling those emotions instead of trying to reprimand them for it is a better way of building a loving dice/player relationship. But we also believe that this also must be done in a safe and controlled space that won't bring any harm to them or to other dice. The Dice Corner is not Time-out but rather a place to give your dice an opportunity to calm down and reflect on their behavior." The Dice Corner comes in 3 pieces, supported and unsupported. Wall and floor pieces can be magnetized using six 5mm(dia)x3mm neodymium magnets. Also added are five "posters" that can be printed out to decorate the walls (best scaled at 2x3cm)
Kategorie
Accessories
Quelle
MyMiniFactory
Veröffentlicht
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
3-teiliger Zusammenbau
Hardware nötig
Supports 1/3
Zusammenbau 1/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

2 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen